- #Serato scratch live sl 1 update
- #Serato scratch live sl 1 software
- #Serato scratch live sl 1 windows
#Serato scratch live sl 1 windows
Rane Control Panel for Windows 7-SP1 and higher (including the ASIO/MIDI driver) v2.4.0.
#Serato scratch live sl 1 update
See “Audio Input Level” on page 30.Scratch live sl1 driver for windows 7 Septemby admin Its the same issue with OSx, where an update with the OS caused the sl1 to stop working even if you have the drivers. Ensure the input level in Scratch Live is set correctly to accept a LINE level signal. If you do not ground your turntables properly, the control signal will be noisy and the tracking of the record position will be erratic.ĭisable all built-in effects on the CD player, including keylock/master tempo. All DJ mixers with turntable inputs have built in grounding points for this purpose. Make sure you have good connections from the ground wires of your turntables to the grounding post of your DJ mixer. Grounding is extremely important when using Scratch Live. Set the tone arms to the recommendations of the cartridge, such that the needle never leaves the record, but not heavy enough that it heats up significantly. Connect it directly to your computer and not through a hub or splitter. Using the provided USB cable, connect your SL1 to an available USB port on your computer. The thrus only work when the SL1 is powered, either by a computer over USB, or by the optional DC power supply.Ĭonnect the SL1 to your computer. If you hear the sound of your control discs instead of music from Scratch Live, you are listening to the thrus rather than the line outputs. Once your THRUS are connected, you can switch to your vinyl or CD’s using the phono/line switch or transform switch on the top of your mixer. In general, turntables are phono level, and CD players are line level. Connect these to your mixer inputs, matching the level of your decks. They allow you to bypass your Scratch Live software, sending audio direct from the SL1 inputs to your mixer (i.e.
The THRU outputs on the SL1 are used if you want to play regular vinyl or CDs during your set. If your mixer has selectable input levels, set these to Line level.Ĭonnect your Thru Outputs to your Mixer. Using the included RCA cables, Connect the LEFT DECK LINE OUTPUTS into a left line input your mixer, and the RIGHT DECK LINE OUTPUTS into a right Line Input of your mixer. The output from Scratch Live comes from the OUTPUTS on the SL1.
Plug the cables from your decks, into the input sockets of the SL1, plugging the left deck into input 1 and right deck into input 2.Ĭonnect the Line Outputs to your Mixer. To integrate an SL1 unit into a typical DJ setup, connect it to your turntables (or CD players) and mixer as follows:Ĭonnect the Turntables or CD Players.
Audio files loaded onto the Virtual Decks are then played back through the outputs of the hardware, with any manipulation of the control discs reproduced on the audio, effectively emulating vinyl control of the files loaded in software. A ‘Virtual Deck’ replicates the movements of the control disc. The SL1 interface converts the control signal coming from each deck into digital audio, to be sent via USB to the Scratch Live software, which decodes that signal into a stream of information based on what the DJ is doing with the control disc.
#Serato scratch live sl 1 software
The Scratch Live control records and CDs are pressed with an audible tone specifically developed for controlling the Scratch Live software application.
0 kommentar(er)
